Slicer Discord
Unifi Camera Compact Junction Box Cap – Modelo 3D imprimible de MakerWorld MakerWorld
Other Tools

Unifi Camera Compact Junction Box Cap

por Ryan · Other Tools
5 Descargas
6 Likes
0 Makes
Ver Modelo
These are a very specific print made to allow a bare ethernet cable to be installed water tight into the Unfi Camera Compact Junction Box when conduit is not being used. This may work with other types of junctions boxes but it was made for the Unifi Compact one. There are 4 models. One has a 6mm hole to allow the installation of one ethernet cable for a clean look that doesn’t have to be water tight. Another 6mm hole but this one is also cut in half to allow you to use an ethernet cable that already has a tip on it. They have notches on them so they lock into place easier and once screwed into junction box won’t move. Another one that has a ¼” hole to allow the use of a ¼” cable gland when install needs to be water tight. And there is also a tool that helps make installation easier.
Categoría
Other Tools
Fuente
MakerWorld
Publicado
Actualizado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

4 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección