Unifi Cloud Key Gen2

I have remised this rack mount for a Unifi USG:
https://www.thingiverse.com/thing:4535702

I've taken the sled that is used for a Raspberry Pi, then adapted it to hold a Unifi CloudKey Gen 2 within the same frame. This would allow you to add/remove or switch around your Pi's and CloudKey Gen2 within your 1RU rack.

I also used this vertical mount for the basic shape, but in two and widened to suit the non Plus version of the CloudKey Gen2.
https://www.thingiverse.com/thing:4928020


As always I am including a link to Tinkercad and my hacky work if people want to take and improve upon it at all.
https://www.tinkercad.com/things/0g5Xg2tuo68

At this point the versions are much the same base:

V1.1 - This is solid under the CloudKey + 4mm hole
V1.4 - Open frame under the CloudKey
V1.4 - Hex pattern under the CloudKey + 4mm hole

The hole is there to add a cable tie around the CloudKey to hold it down if required, note that you need a long and thin cable tie or you could