Universal adjustable AIO FPV camera mount

The smaller part houses the camera with the lens sticking out of the circular hole in the front. The small part slides into the larger part with the screw slots lining up. Use 2 M3 screws and nuts to hold the mount together. The nuts on the inside should rest against the back of the camera to hold it in place. Small bits of foam/popsicle stick may be needed for some thinner cameras.

To adjust the length of the mount, loosen the screws and slide the smaller insert in and out. To remove the camera, loosen and slide the screws so that they no longer press against the rear of the camera. Once the the screws are out of the way, the camera can slide back and up.

To fix the mount into a plane, use hot glue on the back flange. Holes can also be drilled in the back so it can be screwed in but this isn't needed because the mount is so light weight.

This mount provides enough room for the antenna and power wires.