MakerWorld
Organizers
Ver Modelo
Universal Cable Guide
6
Descargas
1
Likes
1
Makes
A simple universal cable holder mountable underneath a wooden table of sorts.It uses a 2 mm wide nail to hold it in place. I recommend you also print out the hammer extension if you cannot reach the hole for the nail.I printed in PLA at 100% for both.If you're having a hard time, I recommend using double-sided tape to hold in place.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
