Thingiverse
Universal parametric GENELEC speaker stand
by aciim
12
Downloads
16
Likes
0
Makes
I found this https://www.prusaprinters.org/prints/4356-genelec-8020d-speaker-stand
But it is wrong size as I need stand for 6010A and 8030A. So I draw my own universal parametric project. You can use this as hollow or filled with sand as there is model with a floor and lid. (Please note that I have NOT printed bigger with the lid yet!)
If you have measurements (widest width between top studs (mid to mid) and the measurement from front stud to back please provide so I can add more sizes.
But it is wrong size as I need stand for 6010A and 8030A. So I draw my own universal parametric project. You can use this as hollow or filled with sand as there is model with a floor and lid. (Please note that I have NOT printed bigger with the lid yet!)
If you have measurements (widest width between top studs (mid to mid) and the measurement from front stud to back please provide so I can add more sizes.
aciim also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!