Universal power strip clamp / bracket

I was looking for a bracket to fasten my power strip to the edge of my desk at an angle, but all the clamps I found seemed very janky. That's why I made this one, which should be super robust and hold almost all brands of power strips. A single clamp will hold an entire power strip if you just need it to be off the ground. If you regularly plug things in and out (for example phone chargers) I recommend using two like in the picture. The clamps leave about 1,5cm of free space underneath the power strip to route the wires. The screw handles have holes in them that fit a 2mm hex key, in case you tighten them too much and can't loosen them just with your hands. The screws are just metric ISO M20 screws so you can make your own if you don't like the ones I modeled. Keep in mind that you should scale the diameter of your own screws to 98%, otherwise the fit will be very tight. In my files the screws are already scaled correctly, so no adjustment should be necessary if you just edit them.