Thingiverse
Universal Spool Holder Adapter
von lgaga
0
Downloads
0
Likes
0
Makes
Accommodates spools with a center hole of 8mm - 80mm (!)
Print two of these adapters, press-fit one M8 nut into each adapter and install them on the M8 rod that came with your spool holder.
It will move very smoothly with just the M8 rod that the holder came with, no bearings necessary. This will work on any spool holer using an M8 rod.
Print two of these adapters, press-fit one M8 nut into each adapter and install them on the M8 rod that came with your spool holder.
It will move very smoothly with just the M8 rod that the holder came with, no bearings necessary. This will work on any spool holer using an M8 rod.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
