Thingiverse
Universal T Handle Nut
von Moose_Man
5
Downloads
4
Likes
1
Makes
Remix of the screw from
https://www.thingiverse.com/thing:5037992
I found the screw did not fit very well. Size was a little too large.
I downsized XY to 92 percent and Z to 100
I also added a negative part (torus) with prusa to remove the start of the thread which was causing some issues.
I used 50 % infill and it's very strong.
Please use the .3mf as the STL does not contain the negative and will need a bit of sanding to get to fit.
https://www.thingiverse.com/thing:5037992
I found the screw did not fit very well. Size was a little too large.
I downsized XY to 92 percent and Z to 100
I also added a negative part (torus) with prusa to remove the start of the thread which was causing some issues.
I used 50 % infill and it's very strong.
Please use the .3mf as the STL does not contain the negative and will need a bit of sanding to get to fit.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!