Thingiverse
UNO Box
von qrxcl
115
Downloads
296
Likes
2
Makes
This is a simple box for UNO cards. It is hold together by 4 small magnets.
The stack of UNO cards can be up to a hight of 35mm.
In the pictures are 108 cards.
magnet size: 10x10x1 mm
round magnets will also work (10mm Ø)
The magnets must be glued in the four recess but be careful to glue them in the right direction so they stick together. But of cause you also can use the box with basic rubber bands!
Update: I am going to make a second box with notches for rubber bands soon so it can be used without magnets...
3. April 2024
created by Nils
The stack of UNO cards can be up to a hight of 35mm.
In the pictures are 108 cards.
magnet size: 10x10x1 mm
round magnets will also work (10mm Ø)
The magnets must be glued in the four recess but be careful to glue them in the right direction so they stick together. But of cause you also can use the box with basic rubber bands!
Update: I am going to make a second box with notches for rubber bands soon so it can be used without magnets...
3. April 2024
created by Nils
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
