Thingiverse
UNO H2O card case
par cera001
27
Téléchargements
19
Likes
0
Makes
This is a card case for the card game UNO H2O.
If it is a genuine case, the card overflows, so I made it a deep case.
2020/1/24
The thing which made the wall a little thicker was added as V2.
I think the strength is slightly up.
In addition, the size and position of the side holes have been changed to eliminate sharp points.
However, I have not printed and checked it myself yet.
2020/1/25
When I tested a new one, it was so small that I couldn't insert the card.
I want to upload it again after correcting it.
2020/1/26
After printing V4, the card was stored without any problem, so I would like to end it.
If you have downloaded up to v3, I think the size is a little small, so I hope you can increase the magnification a little with slice software and print it.
The cutout of H2O on the side was deleted in V4.1.
If it is a genuine case, the card overflows, so I made it a deep case.
2020/1/24
The thing which made the wall a little thicker was added as V2.
I think the strength is slightly up.
In addition, the size and position of the side holes have been changed to eliminate sharp points.
However, I have not printed and checked it myself yet.
2020/1/25
When I tested a new one, it was so small that I couldn't insert the card.
I want to upload it again after correcting it.
2020/1/26
After printing V4, the card was stored without any problem, so I would like to end it.
If you have downloaded up to v3, I think the size is a little small, so I hope you can increase the magnification a little with slice software and print it.
The cutout of H2O on the side was deleted in V4.1.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
