Thingiverse
UP Box Y Axis Replacement Part
por Patate
1
Descargas
1
Likes
0
Makes
This little part broke on my printer, so i re-designed it a bit tougher and hopefully, it'll work for a while, it was a nightmare to replace, especially due to the tension belt !
Printed in ABS from tiertime themselves, with a 0.25 mm layer height, and 80% infill (on an UP mini 2).
Edit : Make absolutely sure that sensor clicks correctly after replacing the part, if not you might wanna consider replacing the other side's part as well (or else printer goes brrrr, literally)
Printed in ABS from tiertime themselves, with a 0.25 mm layer height, and 80% infill (on an UP mini 2).
Edit : Make absolutely sure that sensor clicks correctly after replacing the part, if not you might wanna consider replacing the other side's part as well (or else printer goes brrrr, literally)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
