Thingiverse
UP! MINI filament guide
von Dodger60
4
Downloads
3
Likes
0
Makes
My original Filament guide was wearing badly and causing misfeeds. I also wanted to overcome the issue where the filament jumps off of the spool and causes jams.
This mounts using the same hex screw from the original.
printing in this orientation requires the least support.
This mounts using the same hex screw from the original.
printing in this orientation requires the least support.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!