Thingiverse
UP Plus 2 LED Cover
von ExecWarlock
0
Downloads
0
Likes
0
Makes
First project - a simple cover for the bright LED of the UP Plus 2 that won't stop blinking during printing.
The cover is designed to be put over the edge of the printer and has holes so the light is still slightly visible.
If a Raft is being used, the front will be a bit rough (as you can see on the picture), so you might want to turn the model sideways first or treat the surface post printing.
The cover is designed to be put over the edge of the printer and has holes so the light is still slightly visible.
If a Raft is being used, the front will be a bit rough (as you can see on the picture), so you might want to turn the model sideways first or treat the surface post printing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!