Thingiverse
up stepper cooler
von linuxchic
0
Downloads
0
Likes
0
Makes
The UP and UP Plus 2 have a hot stepper motor in the extruder. With this mod you can add a heatsink against the stepper and a fan on the outsite.
I used a passive heat sink from a computer motherboard and a fan suitable for an UP.
I edited the original (with Tinkercad) so that it would take a wider range of heatsink.
This is a friction fit and no screws etc are necessary - make sure that the mod is tight up against the heatsink.
I used a passive heat sink from a computer motherboard and a fan suitable for an UP.
I edited the original (with Tinkercad) so that it would take a wider range of heatsink.
This is a friction fit and no screws etc are necessary - make sure that the mod is tight up against the heatsink.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!