Upper Freezer Basket with rack mount

I printed 3 of these in total, and I adjusted the design each step of the way. I would say each of these baskets will use about 1 roll of filament, but its better than the $120 that was quoted by reliableparts.ca for a new basket.

In total you need to print (Based on CURA file names):

2x FrzrBsktBtmHalf
2x FrzrBsktRckMnt
3x FrzrBsktBtmLng
2x FrzrBsktBtmShrt
1x FrzrBsktSde

I did the whole thing without supports. And then in the end I would advise using some twist ties for extra support (see pictures). This takes a while to print for sure, but works beautifully when finished, the solid works files are there in case you want to tinker with the design.

Fits the following freezer models:
CFC13M4HW0 , CFC13M5AW0 , CFC13M5AW1 , CFC13M5AW2 , CFC13M6HW0 , CFC13M6HW1 , CFC13M7HW0 , CFC13M7HW1 , CFC15M4HW0 , CFC20M4HW0 , CFC20M4HW1 , CFC25M4HW0 , CFM151P6W3 , F81C13M3W0 , F81C13M3W1 , FFC13C2AW0 , FFC13C3AW0 , FFC13C3AW1 , FFC13C4AW0 , FFC13C4AW1 , FFC13C4AW2 , FFC13C7AW0 , FFC13