US Flag - Firefighter Hueforge

US Flag - Firefighter Hueforge Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 200x200mm in sizeYou may print at higher layer heights below the Min Depth of 1.1mmThe Max Depth is 3.1mm and the Actual Depth is 2.4mm Filaments Used: PLA BambuLab Basic Black Transmission Distance: 0.1 PLA BambuLab Basic Jade White Transmission Distance: 5.7 PLA PolyLite Wine Red Transmission Distance: 1.7This print uses 3 unique filaments***attached .3mf file prints the first 6 layers at 0.16mm then the rest at 0.08mm for faster print time******the layer numbers will be different but the layer height will be the same*** Swap Instructions: Start with Black At layer #18 (1.52mm) swap to Jade White At layer #24 (2mm) swap to Black At layer #26 (2.16mm) swap to Wine Red for the rest. Check out my US Flags & Military Collection here Check out my Hueforge Display Collection here (Frames, Stands, Book Nooks) Check out my other models and hueforge files here Don't fo