Thingiverse
USB C cover
by ErikWTN
252
Downloads
249
Likes
2
Makes
Simple cover to keep the dirt out of your USB C port.
Print in TPU at 0.2mm layer height or less. This is a tiny part with tight tolerances so if your printer isn't calibrated it might not fit correctly. It should fit snug but be fairly easy to remove.
UPDATE: 11/29/23
Increased the inner slot size and adjusted insert size slightly for a better fit and to decrease wear on the contacts of the connector.
Print in TPU at 0.2mm layer height or less. This is a tiny part with tight tolerances so if your printer isn't calibrated it might not fit correctly. It should fit snug but be fairly easy to remove.
UPDATE: 11/29/23
Increased the inner slot size and adjusted insert size slightly for a better fit and to decrease wear on the contacts of the connector.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
