Thingiverse
USB-C Trigger/Decoy Board Case
von Alexmkiwi
2
Downloads
2
Likes
0
Makes
My case for the USB-C trigger/decoy board pictured.
You will need to cut off the notched guidance tab on the blue terminal connector for this case to fit.
You will also need 4 x M3x10mm to screw the case together.
Edit: I added a debossed "+" and "-" near the terminals for easier identification.
You will need to cut off the notched guidance tab on the blue terminal connector for this case to fit.
You will also need 4 x M3x10mm to screw the case together.
Edit: I added a debossed "+" and "-" near the terminals for easier identification.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!