MakerWorld
Office
USB Cable Holder
by CatWhisker
223
Downloads
57
Likes
131
Makes
A USB cable holder. It's in extra draft quality so you will see lines but I just wanted something that was quick to print - I didn't need it perfect looking. I also wanted something that held the end of the USB cable so that I could see if it was usb c or micro usb etc and I achieved this with the little cutout at the front. There are 6 slots that are of equal size and the end one is slightly smaller as I had a very short cable so didn't need it to be as wide. Printing time is 1 hour
Sign in to leave a comment
Sign in