Thingiverse
USB Cable holder
von joost_m
11
Downloads
8
Likes
0
Makes
This is a USB cable holder i created because of most cable holders are to big and do not fit properly.
There are 2 versions.
A version that u can screw on and a version to put double side tape on.
Double side tape u can find here: https://tinyurl.com/double-side-tape
The Fusion360 ".f3d" files are included (as usual)
If anyone wants to remix them, have fun and don't forget to upload to the community.
Total print-cost is about €0,05 in PLA/PET-G for the screw-on version
Total print-cost is about €0,07 in PLA/PET-G for the tape version
Happy printing!!!
There are 2 versions.
A version that u can screw on and a version to put double side tape on.
Double side tape u can find here: https://tinyurl.com/double-side-tape
The Fusion360 ".f3d" files are included (as usual)
If anyone wants to remix them, have fun and don't forget to upload to the community.
Total print-cost is about €0,05 in PLA/PET-G for the screw-on version
Total print-cost is about €0,07 in PLA/PET-G for the tape version
Happy printing!!!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
