Thingiverse
USB Camera Microscope - replacement parts
door Hutoman
8
Downloads
9
Likes
0
Makes
USB Microscope camera replacement end-cap and molder piece for mount.
Printed with Inland Silk Silver PLA in photos.
End-cap fits perfectly printed base down at 0.2 resolution. 1.2mm shell, and fill density at 20% (this shouldn't matter).
Holder piece was printed on its side with supports for the rod and ball, at 0.2 resolution. 1.2mm shell, and fill density at 20%.
A more rigid PLA may give a more sturdy grip, as this silk PLA is slightly more flexible than others. Holder piece grabs on well, but does have a small amount of play once microscope is in place. This could be adjusted to a slightly tighter fit, but it holds the scope steady and still holds on well.
Printed with Inland Silk Silver PLA in photos.
End-cap fits perfectly printed base down at 0.2 resolution. 1.2mm shell, and fill density at 20% (this shouldn't matter).
Holder piece was printed on its side with supports for the rod and ball, at 0.2 resolution. 1.2mm shell, and fill density at 20%.
A more rigid PLA may give a more sturdy grip, as this silk PLA is slightly more flexible than others. Holder piece grabs on well, but does have a small amount of play once microscope is in place. This could be adjusted to a slightly tighter fit, but it holds the scope steady and still holds on well.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!