Thingiverse
USB Desk Mount
by ghtharant
8
Downloads
3
Likes
0
Makes
I had the USB extension lying around but I am 95% sure that it is [this Monoprice item.](https://www.monoprice.com/product?p_id=5432)
I printed mine in PETG only because it was already loaded in the printer. PLA would be fine as well. I included 2 files, one with just the bare model which should print just fine. You could probably print it with or without supports (just might be a bit droopy without them).
The second has “support” included as long as you print it upright. Just cut out the two sacrificial layers after it is done.
I printed mine in PETG only because it was already loaded in the printer. PLA would be fine as well. I included 2 files, one with just the bare model which should print just fine. You could probably print it with or without supports (just might be a bit droopy without them).
The second has “support” included as long as you print it upright. Just cut out the two sacrificial layers after it is done.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
