MakerWorld
Gadgets
Zum Modell
USB Flash Drive Cap
59
Downloads
15
Likes
38
Makes
Certain slim/key sized USB flash drives are prone to the metal casing bending and "bowing" in. I created this end-cap in an effort to reduce the chances of my Kingston DataTraveler SE9 Gen2 drive caving in.There are two versions: SHORT - outer wall is 7 mm tall, inner tongue is 10 mm LONG - outer wall is 12 mm tall, inner tongue is still 10 mm Print SettingsPrinter Brand:FlashForgePrinter: FlashForge Creator ProRafts:NoSupports: NoResolution:0.1Infill: 75%Notes:Due to the tight tolerances and small gap between the outer walls and the inner "tongue", consider printing at 0.1 layer height.Category: Computer
Tarrant1701 veröffentlicht auch auf
62 zusätzliche Modelle auf 2 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!