Thingiverse
USB Flash Drive / Pendrive Case Keyring
55
Downloads
61
Likes
2
Makes
This is a one piece pen-drive enclose case for Sony 8gb USB, might apply to other models.
>The print needs to be stopped around Z=5,5 so as the flashdrive board can be placed inside the case. Once you that done, you can resume the print and the PCB will be embedded in the case.
I´ve printed in 0,3mm layers without support but i ended up with a bit lack of resolution so i would recommend printing it at 0,1-0,15mm layers.
>The print needs to be stopped around Z=5,5 so as the flashdrive board can be placed inside the case. Once you that done, you can resume the print and the PCB will be embedded in the case.
I´ve printed in 0,3mm layers without support but i ended up with a bit lack of resolution so i would recommend printing it at 0,1-0,15mm layers.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
