USB fork socket

Try it out and see if it works.

42mm fork clamp with 29mm receptacle, for use with a USB plug or whatever fits in there. This was initially designed for use on a Royal Enfield GT650 or INT650 but should work on anything with a 42mm fork. Bolt holes are designed for 4mm hex cap bolts and secured with M4 6mm brass threaded heat inserts. I am uploading this before trying it so that it can be tested on a wider audience than just myself.

If you own an Enfield, you'll just need:

USB socket
Wire
2.8mm 2 pin connector
Two M4 hex cap bolts
Two M4 threaded inserts

All of these items can be purchased off of amazon. When building the USB utilize the accessory plug located in the headlamp. The plug will not be plugged into anything when the headlamp is removed, it is usually yellow or green. The design was made with PLA shrink rates in mind, so when using another material adjust accordingly. Also when using PLA be sure to weather proof it otherwise it'll fail.