Thingiverse
USB µISP Case
by builttospec
5
Downloads
6
Likes
0
Makes
This is a nice little case for the Geppetto Electronics USB µISP.
It uses 3mm acrylic and 2mm(.08") acrylic.
This case also allows access to the switch on the board.
You can find the instructions here: http://www.built-to-spec.com/blog/usb-microisp-case/
If you don't have a laser cutter, you can grab one of these cases from our store here: http://builttospecstore.storenvy.com/products/13521426-usb-isp-case
Design made by Thingiverse user RoboLemur.
It uses 3mm acrylic and 2mm(.08") acrylic.
This case also allows access to the switch on the board.
You can find the instructions here: http://www.built-to-spec.com/blog/usb-microisp-case/
If you don't have a laser cutter, you can grab one of these cases from our store here: http://builttospecstore.storenvy.com/products/13521426-usb-isp-case
Design made by Thingiverse user RoboLemur.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!