Thingiverse
USB Port Protector
door McWalrus
44
Downloads
36
Likes
1
Makes
This is a simple USB protector to put inside a USB port that isn't being used to protect it from dust and dirt. Print time for me was only 17 minutes so you could easily just print off a bunch of these to put in your desk and use when needed.
Edit - When you put this into a slicing program you may need to scale it down to 1000% and rotate it 90 degrees if you downloaded it before this edit. If not then you are fine.
Edit - When you put this into a slicing program you may need to scale it down to 1000% and rotate it 90 degrees if you downloaded it before this edit. If not then you are fine.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!