Thingiverse
USB Power Blocker Case
by fatmann66
1
Downloads
0
Likes
0
Makes
This is a simple case for USB power blocker for 3D printers, OctoPrint, or Raspberry Pi.
Found here: https://www.tindie.com/products/fatmannmakes/usb-power-blocker-inhibitor/
The alignment pins are very small, but I never had an issue printing them. Put a few drops of CA glue on the corners to seal.
Optionally can use some hot glue on both sides of the board.
Found here: https://www.tindie.com/products/fatmannmakes/usb-power-blocker-inhibitor/
The alignment pins are very small, but I never had an issue printing them. Put a few drops of CA glue on the corners to seal.
Optionally can use some hot glue on both sides of the board.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
