MakerWorld
Gadgets
Model downloaden
USB-powered magnet stirrer
34
Downloads
58
Likes
10
Makes
This is a simple, USB-powered magnet stirrer designed using Bambu Lab hardware. It’s a fun and practical project! What You’ll NeedPrintable parts (5 total)BaseUSB cord strain relieverMotor mountMagnet holderLidRequired hardware14 × M2x5 mm screws2 × Magnets (30×10×3 mm)1 × Motor1 × Control board1 × Potentiometer1 × On/off switchAdditional itemsA stir barA suitable container (e.g., an Erlenmeyer flask)Printing instructionsMagnet holderPause the print just before the magnet slots are sealed. (This is preset in the default print profile.)Insert the magnets and resume printing. BaseAdd supports for the underside holes and the USB cable holder on the side. (Preset in the default print profile.)Motor mountAdd supports under the model to properly print the top section. (Also preset in the default print profile.)Assembly instructions1. Install the on/off switchConnect the wires to the switch.Place it in its designated slot on the front (bottom hole, below the potentiometer).Secure with 2 screw
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!