Thingiverse
USB Stick Holder
por HElados
208
Descargas
113
Likes
0
Makes
USB Stick Holder, designed to be mounted to the inside of cabinet doors for flat storage against the surface the holder is mounted to. Mounting holes intended for counter sink screws (Spax screws fit well).
Print with PLA with good bridging settings, because the height of the USB holders is determined by a bridge.
USB Sticks should not be wider than 21mm, and higher than 10mm (center of slot at 5 mm from wall). USB stick length not constrained by holder.
Fusion360 design file included for customization.
Print with PLA with good bridging settings, because the height of the USB holders is determined by a bridge.
USB Sticks should not be wider than 21mm, and higher than 10mm (center of slot at 5 mm from wall). USB stick length not constrained by holder.
Fusion360 design file included for customization.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!