Thingiverse
USBASP V2 Case
por WayneBooth
11
Descargas
5
Likes
0
Makes
A simple case for the ubiquitous USBASP.
Printing simply lay both halves on their backs, no need for support or rim.
The two halves clip together over the USBASP.
Their are two holes for the status LEDs, I used some clear filament as a light pipe, but this is not necessary.
Printing simply lay both halves on their backs, no need for support or rim.
The two halves clip together over the USBASP.
Their are two holes for the status LEDs, I used some clear filament as a light pipe, but this is not necessary.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!