Thingiverse
USBtin D-SUB case
por theflope
2
Descargas
4
Likes
0
Makes
This is a case for the USBtin (https://www.fischl.de/usbtin/) CAN bus USB adapter.
The design is intended to protect the PCB and at de same time adapt to the widely used D-SUB connector.
The lid should click in place nicely but is not intended to be totally tight.
I used two M2*4 self tapping screws to fix the PCB in place. For the D-SUB connection you will need a standard panel mount female d-sub connector socket and matching mounting bolts.
Then just solder the CAN wires to the D-SUB interface and use the screw terminals to connect to the USBtin.
The design is intended to protect the PCB and at de same time adapt to the widely used D-SUB connector.
The lid should click in place nicely but is not intended to be totally tight.
I used two M2*4 self tapping screws to fix the PCB in place. For the D-SUB connection you will need a standard panel mount female d-sub connector socket and matching mounting bolts.
Then just solder the CAN wires to the D-SUB interface and use the screw terminals to connect to the USBtin.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
