Thingiverse
uSDX Case with speaker
von sanamon
5
Downloads
4
Likes
0
Makes
uSDX case for the DL2MAN (http://www.dl2man.de) sandwich.
Prepared for a small speaker, and for using a barrel power bulkhead connector on same side as antenna connectors so all connectors are on same side.
Speaker: Visaton K 50 FL fits. https://www.newark.com/visaton/2949/mini-loudspeaker-5-cm-16-ohm/dp/54X6591
DC Barrel connector: https://www.elfa.se/en/power-jack-1x5-5mm-straight-rnd-connect-rnd-205-00905/p/30129725
I use this for VFO knob: http://www.mouser.com/ProductDetail/davies-molding/1231-m/?qs=AaRlLUpeMswOSG40sk9WzA%3d%3d
The design is made up of just 2 parts (+buttons), Mount the sandwitch to the bottom part first, then put top port on.
print with support everywhere.
I use 35% infill
A drop of superglue helps to keep the nuts in place. Use M3 screws and nuts.
Prepared for a small speaker, and for using a barrel power bulkhead connector on same side as antenna connectors so all connectors are on same side.
Speaker: Visaton K 50 FL fits. https://www.newark.com/visaton/2949/mini-loudspeaker-5-cm-16-ohm/dp/54X6591
DC Barrel connector: https://www.elfa.se/en/power-jack-1x5-5mm-straight-rnd-connect-rnd-205-00905/p/30129725
I use this for VFO knob: http://www.mouser.com/ProductDetail/davies-molding/1231-m/?qs=AaRlLUpeMswOSG40sk9WzA%3d%3d
The design is made up of just 2 parts (+buttons), Mount the sandwitch to the bottom part first, then put top port on.
print with support everywhere.
I use 35% infill
A drop of superglue helps to keep the nuts in place. Use M3 screws and nuts.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
