UTComp Enclosure Supports

These are parts to support the LCD and button board of an UTComp Pro 3.2" LCD and button board, inside the official available case. There's nothing that supports the LCD or button board in place, so these pieces are designed to hold those two pieces in place and sit flush against the back cover once clipped on.

The buttons protrude enough that they're not sticking out too far, but enough to allow for easy use.

One thing of note is that the clip in the removable part of the rear cover will interfere with one of the button mounts. I may do a revision for this, else you can trim either the support or the clip to suit.

Update 04/01/2019 - Realised I didn't have the right height for PCB-2.stl so updated it and have tested it.