Utility blade scraper

Scraper designed to use standard utility knife blades and uses the same M2.6 x 8 mm screws from the MakerWorld scraper.Assembly InstructionsBegin by inserting the screws partway into the bottom of the handle piece.Add the flat middle piece, aligning the holes, and continue threading the screws slightly.Next, position the thumb piece on top and start the screws into it as well.Once all three layers are aligned, insert the blade into the slot in the handle.Gradually tighten both screws, alternating between them a little at a time to keep the parts aligned and prevent binding. Ensure the blade is fully seated in the handle slot and not pinched underneath the flat piece before final tightening.Blade ReplacementTo replace the blade, loosen the screws just enough to relieve pressure no need to remove them completely. Slide out the old blade, insert the new one, and retighten evenly.