Utility pole diorama

This is a utility pole model printed using AMS (of course, you can also hand-paint it if you don't have AMS). The approximate scale is 1:64, making it suitable for use in a 64-scale car model scene. The power wires can be made directly using black filament. As shown in the picture, cut out six sections of filament of equal length. The beginning and end of each filament should be trimmed at a 45-degree angle (depending on how far you want the power wire to droop). Glue the filaments to the pole. I recommended using quick-drying glue. This step requires patience Note!!!!!! Do not change the support settings in the 3MF file; these supports are very easy to remove. Wait until the print is completely cool before removing it. Be patient when removing the supports to avoid damaging the model (if damaged, you can use glue to restore it).