Thingiverse
UV Exposure Box
di Neophyte
6
Download
1
Likes
0
Makes
UV exposure box with door to fit under standard 36W UV nail lamp.
No support is necessary. After print remove the thin support strip from the slide rails at the top. Should be very easy to remove.
Fit the door to the box with small pieces of filament in the hinge holes.
At the top opening I slid a "screw clip" over the plastic so that the magnet in the door can stick there. The magnet is a 20mm x 4mm magnet.
No support is necessary. After print remove the thin support strip from the slide rails at the top. Should be very easy to remove.
Fit the door to the box with small pieces of filament in the hinge holes.
At the top opening I slid a "screw clip" over the plastic so that the magnet in the door can stick there. The magnet is a 20mm x 4mm magnet.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
