v-core-3 z-chain

A simple z-chain that replaces the cable strain release part on the v-core-3 back z-arm. Requires you to bore a 20mm hole in your electronics panel.

The chain used is the Befenybay R18 10X15mm. I'm using ~18 elements (~1/3rds of a 1m kit). This is with the panel mount terminating roughly at half-height of the printer. The further up you want to terminate, the more elements you need to add.

You'll need 6x Ruthex M3 heatset inserts and (ideally) 6x M3x6 or M3x8 countersunk screws to mount the chain. You can also opt to drill through 3 more holes for the M3 screws and use nuts from the inside of the panels.