Slicer Discord
V-Engine KeyRing V2.0 – 3D-Druckmodell von MakerWorld MakerWorld
Gadgets

V-Engine KeyRing V2.0

1.3k Downloads
474 Likes
910 Makes
Zum Modell
KeyRing of a combustion V45/V60/V90/V180-engine with turning crankshaft and moving pistons.Release 2.0 d.d. 28-8-2025: improved clicking of crank cheek/crank case. PrintingNo supports.I printed with PLA+, layer height 0.15 mm.AssemblyNo glue.Use some oil or grease between moving parts for a smooth operation.- Place the piston rods on the crankpin (upper piston rod upside down).- Screw the pivoting knob on the crankpin.- Place the pistons with the piston pins on the piston rods.- Click the pistons in the cylinders, and at the same time click the crankshaft in the crankcase.OperationPut your finger on the pivoting knob to turn the crankshaft.This design is a spin-off of my “Engine KeyRing”.Engine KeyRing by Bootjevaarder - MakerWorld
Kategorie
Gadgets
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
aufwändige Nachbearbeitung
Einteilig Hardware nötig
Supports 1/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 3/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Mindest-Druckbett
50 mm (Klein)
Nachbearbeitung
Schleifen, Kleben, Hardware
Software
Cura, PrusaSlicer o. Ä.
Gleicher Designer, mehr Plattformen

Bootjevaarder veröffentlicht auch auf

127 zusätzliche Modelle auf 1 weiteren Plattformen

Verifiziert durch übereinstimmende Modelltitel über Plattformen hinweg.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen