V-Pet GO Pendulum Shell

--------------
9:10PM CST
5/12/2026
New Design Changes:
Added an extra 0.3mm to make T-Display devices fit better.
Added space for MPU6050
----------------------------------------------------------------------------

A Pendulum-style shell for the ESP32 Lilygo/Tenstar TTGO T-Display. You will need the firmware files from the V-Pet GO project in Digitama Hatchery made by Rurounik. Currently still somewhat of a WIP but nearing the end of designing. Reach out if you have questions.

Refer to image 3 in this set for a wiring guide.

The part in the Miscellaneous STL with a hole through it holds the clacker. Put the metal/3D printed dowel through that hole, then glue the base of it to the area labeled clacker.

The grooves are to organize the wires. Prongs (the two resistors mentioned) go through the top slits, with Pin32 being the top prong and GND as the bottom prong. Best to solder 3mm x .1mm nickel strips to the ends of the resistors and then r