Thingiverse
V2.0 Thrustmaster Warthog replacement gimbal
door Psyrg
108
Downloads
68
Likes
5
Makes
Please read!
V2.0 of the gimbal is to address issues with calibration and strength in the gimbal, but is unfortunately a little more difficult to assemble. Of note is that the stock sensor mount is reused, but it has to be modified to fit. As this is a one way modification, I am trying to source a second base to get good pictures of the process for the build. Until then, I only have my prototype modification, which isn't pretty.
Instructions to follow.
My Thrustmaster Warthog base wore down and eventually had quite a bit of play in the gimbal. This set of STL files replaces the stock gimbal with one that uses Tamiya 1280 bearings, which are commonly available from hobby stores.
Bearing dimensions
Outer Diameter 12.0 mm
Bore 8.0 mm
Width 3.5 mm
No other parts are required other than those in the joystick base.
If desired, a 3D printable replacement sensor mount has kindly been made by Nopileus so you don't have to modify your stock one.
https://www.pru
V2.0 of the gimbal is to address issues with calibration and strength in the gimbal, but is unfortunately a little more difficult to assemble. Of note is that the stock sensor mount is reused, but it has to be modified to fit. As this is a one way modification, I am trying to source a second base to get good pictures of the process for the build. Until then, I only have my prototype modification, which isn't pretty.
Instructions to follow.
My Thrustmaster Warthog base wore down and eventually had quite a bit of play in the gimbal. This set of STL files replaces the stock gimbal with one that uses Tamiya 1280 bearings, which are commonly available from hobby stores.
Bearing dimensions
Outer Diameter 12.0 mm
Bore 8.0 mm
Width 3.5 mm
No other parts are required other than those in the joystick base.
If desired, a 3D printable replacement sensor mount has kindly been made by Nopileus so you don't have to modify your stock one.
https://www.pru
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
