Thingiverse
V2 Engine Fidget toy (WORKING)
por Jzatz
1
Descargas
0
Likes
0
Makes
My V2 engine fidget toy for a school project. To connect the crank to the engine block, slide the crankholder through the crankarm, and insert. Might take a few tries.
Cura:
-5% support infill ( any higher and supports can damage the crank)
-20% print infill (cubic)
-220C printing temp, 75C bed temp
-Shell thickness.8mm
-Layer height .2mm
-print speed 50mm/s
-wall speed 25mm/s
-travel speed 150mm/s
-retraction on
these settings work for me, but each printer is different :)
Cura:
-5% support infill ( any higher and supports can damage the crank)
-20% print infill (cubic)
-220C printing temp, 75C bed temp
-Shell thickness.8mm
-Layer height .2mm
-print speed 50mm/s
-wall speed 25mm/s
-travel speed 150mm/s
-retraction on
these settings work for me, but each printer is different :)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
