Slicer Discord
V2 Engine - No fasteners required – Modelo 3D imprimible de Thingiverse Thingiverse
V2 Engine - No fasteners required – Bild 1 V2 Engine - No fasteners required – Bild 2 V2 Engine - No fasteners required – Bild 3 V2 Engine - No fasteners required – Bild 4 V2 Engine - No fasteners required – Bild 5 V2 Engine - No fasteners required – Bild 6
Engineering

V2 Engine - No fasteners required

4 Descargas
2 Likes
0 Makes
Ver Modelo
A V2 Engine that snaps together and requires no extra fasteners.

To assemble this you will need:
1 Engine base
2 Engine top
1 Driveshaft
2 Piston arm
2 Piston head
5+ Connector clips

Print orientations:
Base- Stand upright
Tops- Rotate 90 degrees so that the middle part (where the two connect) is on the build plate
Piston arms, driveshaft, connectors- Lie flat
Piston heads- Face down, pivot point facing upwards.

Set supports to >45deg so supports do not generate under the large overhangs
Categoría
Engineering
Fuente
Thingiverse
Publicado
Lo que necesitas para imprimir: Principiante Baja confianza
Pieza única
Soportes 1/3
Ensamblaje 0/3
Ajustes 1/3
Tamaño de cama 0/3
Postproceso 0/3
Impresora
FDM / FFF
Formato de archivo
STL
Material
PLA
Software
Cura, PrusaSlicer o similar
Aún no hay valoraciones
Aún no hay comentarios – ¡sé el primero!

Modelos similares

6 Sugerencias
Feed Blog Slicer Calculadora Búsqueda por imagen Enviar Contacto Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Añadir a colección