Thingiverse
V6 Trigger contact Shuttle
von OfficerSkidmark
0
Downloads
1
Likes
0
Makes
This is a WIP intended for the use with an SLS 3D printer.
after receiving a pile of broken P90s one of them had a broken contact shuttle. instead of replacing the whole harness i wanted to try and SLS print a new shuttle.
this is the V1 version based off the original injection molded part.
after receiving a pile of broken P90s one of them had a broken contact shuttle. instead of replacing the whole harness i wanted to try and SLS print a new shuttle.
this is the V1 version based off the original injection molded part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!