V8 Phone Stand

This is v1. Will print this eveing and report back. (BRE says the mustang is a bit messy so may have to rebuild with his fixed version)

v2 will be raised with wheels on and a gap for phone charge lead.

v6 decided the phone support should be a car part so used a wing - and also added tyre at the rear to support it - this requries support switched on - not something I normally use but thought would give it a go - could be tricky untangling the wheels :-/

Added a pic of v5 (before adding wing) printing and something not quite right - Slic3r reported errors/holes which I probably shouldnt have ignored!

Added another pic of v5 - bonnet/hood wrong shape, phone support wrong angle, support material a nightmare!

I'm going to start from scratch - these 3D car scans aren't up to much :-(

Nice one here; https://www.thingiverse.com/make:784883