Vacuum Bag Mount Holder

Wanted to add a hepa bag to my wet / dry vacuum. I wanted to protect the motor as need to vacuum up a lot small particles (ash). Uses 2x M2 8mm bolts (with nuts) to hold on the clips tabs. I designed this as separate part so it can be printed on its side which will strength it + make it more flexible and, if it breaks make it really easy to replace just that part. It also uses a c-clip for the pin : 1/8th.

The bag holder has a lot of support that is annoying to remove. Get a screw drive along the edge and you can pry it out pretty easy. I had to screw out the hinges to as my supports didn't allow them to be perfect circles. I uased a 5/64th inch drill bit.

The bags I am using are these :

VACBP6 HEPA Filter Bags Replacement for Atrix Ergo 8 Quart Backpack Vacuum, Replace Part VACBP36V VACBP1 VACBPAI

https://www.amazon.com/gp/product/B0983B3VWW/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

Size of mounting part of bag is 10.5cm x 9cm x 3mm : The opening is centere