Thingiverse
Vacuum Pump Foot
von jjohnson98
2
Downloads
0
Likes
0
Makes
Did drop your vacuum pump and break the plastic foot?
Did you look for a replacement and say, "No way I'm spending $25 for a piece of plastic! That's outrageous!".
Then you've come to the right place.
This is a replacement part for the base foot, PR-62, on JB Industries vacuum pumps
Should fit these models: DV-42N, DV-85N, DV-142N, DV-200N, DV-285, DV-3E, DV-4E, and DV-6E.
I've tried it on a DV-142N and DV-200N and it fits perfectly.
It uses the same rubber feet as the original foot, PR-59.
Printing out of PTEG is probably best as this would get exposed to the occasional vacuum pump oil spill and I don't think PLA handles oil all that well. Also the PTEG is a bit more flexy and dampens vibration a bit more.
Did you look for a replacement and say, "No way I'm spending $25 for a piece of plastic! That's outrageous!".
Then you've come to the right place.
This is a replacement part for the base foot, PR-62, on JB Industries vacuum pumps
Should fit these models: DV-42N, DV-85N, DV-142N, DV-200N, DV-285, DV-3E, DV-4E, and DV-6E.
I've tried it on a DV-142N and DV-200N and it fits perfectly.
It uses the same rubber feet as the original foot, PR-59.
Printing out of PTEG is probably best as this would get exposed to the occasional vacuum pump oil spill and I don't think PLA handles oil all that well. Also the PTEG is a bit more flexy and dampens vibration a bit more.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
