Thingiverse
Vacuum Release valve
von BlueSkys12
10
Downloads
13
Likes
0
Makes
This is a vacuum release valve for a shopvac add on 5 gallon bucket.
Too much suction collapses the bucket.
5/16 x 3" bolt or smaller diameter found at hardware store.
any spring of your choice
See picture on how to assemble.
You can use duck tape or any type of sealant for a gasket (flex seal?) between the body and the stopvalve.
The idea was how quality cheap can you make it functional.
I glued the bolt hex head into the stop valve cap or you can fuse the bolt in the cap by using a soldering iron and extra filament..
Using the spring spacer depends on how large and tall your spring is.
Print at 20%
Too much suction collapses the bucket.
5/16 x 3" bolt or smaller diameter found at hardware store.
any spring of your choice
See picture on how to assemble.
You can use duck tape or any type of sealant for a gasket (flex seal?) between the body and the stopvalve.
The idea was how quality cheap can you make it functional.
I glued the bolt hex head into the stop valve cap or you can fuse the bolt in the cap by using a soldering iron and extra filament..
Using the spring spacer depends on how large and tall your spring is.
Print at 20%
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!