Thingiverse
Vacuum wall mount
by Krymax
0
Downloads
0
Likes
0
Makes
Vacuum cleaner mount with 2 adapter holders and charging cable slot
Recommended print material: PETG or ASA. I used ASA due to its higher heat resistance where Tg_ASA ≈ 100°C (my kitchen gets a lot of direct sunlight) and its slightly higher stiffness/strength. PETG should work just as well for this application.
You'll also need 2 nails/screws for mounting. The damper pads were cut from dense foam and glued on, but any TPE/TPU with a sufficiently low Shore hardness would work as well.
Recommended print material: PETG or ASA. I used ASA due to its higher heat resistance where Tg_ASA ≈ 100°C (my kitchen gets a lot of direct sunlight) and its slightly higher stiffness/strength. PETG should work just as well for this application.
You'll also need 2 nails/screws for mounting. The damper pads were cut from dense foam and glued on, but any TPE/TPU with a sufficiently low Shore hardness would work as well.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
