Thingiverse
Vader Glow Lithography
door CoolArts
30
Downloads
30
Likes
0
Makes
## Small lithography of Vader & DeathStar.
It's printed in 2 steps with a single extruder printer.
* First you must print the glow base. It's just 135 x 94 x 1,2 mm without the circular rafts. Scale just x & y axes to make it bigger but not taller.
* Once the base is printed and the printer ends, change the filament and readjust printer z-axis those +1,2 mm to print the second layer.
* Open the positive or negative design, scale it in place the same as the base (remember... only x & y axes).
* Send it to print
The positive design of the drawing is printed here, a negative one is also included.
Base, positive and negative layers are 1,2 mm tall. They are ok for 100, 200, 300 & 400 microns.
## Happy Printing for the Darkness!.
It's printed in 2 steps with a single extruder printer.
* First you must print the glow base. It's just 135 x 94 x 1,2 mm without the circular rafts. Scale just x & y axes to make it bigger but not taller.
* Once the base is printed and the printer ends, change the filament and readjust printer z-axis those +1,2 mm to print the second layer.
* Open the positive or negative design, scale it in place the same as the base (remember... only x & y axes).
* Send it to print
The positive design of the drawing is printed here, a negative one is also included.
Base, positive and negative layers are 1,2 mm tall. They are ok for 100, 200, 300 & 400 microns.
## Happy Printing for the Darkness!.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
